The 212iLM Mullion should be Surface Mounted with a 1/4” hole for the wires centered approximately 5/8 of an inch underneath the center of bottom mounting hole (refer to the included mounting template).įor input noteAlthough the 212iLM will work with AC or DC voltage, it is recommended to use a filtered and regulated power supply for it’s ability to maintain voltage and reduce the possibility of voltage spikes.ġ. Mounting height is the same for an electrical switch, 48" on center. Select the appropriate location for the 212iLM Mullion. You will need a drill, drill bits1/8, 3/16 & 5/16 (for the plastic anchors), wire strippers, regular & small flat blade screwdrivers, a marking pen or pencil, some heat shrinkable tubing (for the wire splices), a ruler or measuring tape, silicone to seal any holes and possibly some electrical tape to hold the wires together or the template in place.Ģ12iLM Mullion Dimensions: 6 ½”L x 1 ¾”W x 1 1/8”D Taking this inventory will familiarize you with the components as well as ensure that you have a complete parts list. Please check the contents of this package and verify all components in the packing list are present. Literature: (1) 212 Standalone Mullion Instruction Manual Hardware: (1) Hardware Pack containing: (2) 8 x1¼” Panhead Slotted Machine Screw (2) 8 x 1¼” Round Head Wood Screw (2) 6-8 x ¾” Plastic Anchor, (1) 212iLM mounting template.
Keypad: (1) 212iLM Mullion keypad Harnesses: (1) 8 Conductor wire harness Wrenches: (1) Standard 5/64 allen wrench Q Section 1: Unpacking and checking the packing list